Select Page

Guest author: Sarah Curry of Hydrovane International Marine

Article from Island Cruising NZ, courtesy of Viki Moore

Once upon a time our tight quartered boat show booth was jammed full of sailors holding cocktails, regaling us with exciting past and future sailing plans as we answered installation questions in person. As we haven’t had the chance to attend boat shows in many months, we felt a run down of the common Q’s we are asked at boat shows would be of interest!

I will preface the installation questions with the obvious: “What is a windvane self steering system?”

  • A mechanical autopilot (requires no power)
  • Steers a wind based course (an angle to the wind), rather than a compass based course
  • This is achieved by setting your course, ie, setting the Vane directly into the wind. As the boat falls off this course, the wind acts on either side of the Vane, pushing it over, and transferring this action through the mechanism below to (most commonly) either 1) an auxiliary rudder or 2) a servo pendulum which acts on the main rudder, to bring boat back on course.

1) My boat has dinghy davits. Can I keep them and install a windvane?
Yes. Davits might just be our favorite addition to our boat, Kaiquest, a Jeanneau SO 43. Will and I are now cruising with twin toddler boys in Mexico, and any gear that makes life easier is cheered at every single use! As long as the Vane can pivot above the dinghy and the auxiliary rudder can turn below, there is no problem to use both at the same time. In fact, the Hydrovane becomes a good lashing point for helping stabilize the dinghy. Like us, you will probably hoist the dinghy onto the foredeck for long passages. Traditional servo pendulum systems will not work with your davits but other types, like the direct connect servo style windvane, potentially make it possible to have both.

2) Can I install the windvane off center on the transom?
With boat design moving to swim steps and now dropdown transoms, this is an obvious question for many. The answer is a definitive YES for auxiliary rudder type systems. Unsure about the concept? It goes way back… The word starboard is historically derived from terms meaning “Steer” and “Side of the boat” – and was the side of the boat steering oars were placed because most sailors were right handed. Whether you mount an auxiliary rudder windvane to port or starboard, you’ll find performance does not change. A centerline installation is most esthetically pleasing for some boats. Servo pendulum style windvane are only suited to a centerline installation.

3) I just installed an arch. Can I still fit a windvane?
Yes. Arches are common on cruising boats. Servo pendulum type windvanes are usually lower profile and can fit easily under an arch. The Hydrovane has a larger Vane than servo systems as that is where it derives its power. We simply configure your unit with a wide, rather than tall, Vane and use a shorter Shaft to ensure there is airspace for the Vane to move freely underneath the arch. Alternatively, we can configure the unit with the Vane above the arch.

4) Can I install and use a windvane on my multihull?
Yes. The reality is that many cruising cats are more about comfort than maximizing speed. What is her displacement? What boat speed is she sailing (relative to wind strength)? Within these limitations the benefits of a windvane can definitely be enjoyed by a cruising multihull. The best position for most types of windvane is at end of a pontoon/hull. This is particularly important for the Hydrovane for optimal rudder leverage.

5) I like the idea of steering redundancy, but why wouldn’t I install a second autopilot instead?
Hey, we love our below deck autopilot; it’s great for motoring and short hops, but that comfort changes when a few hours of usage becomes 24 x 7. The power consumption of an electronic autopilot in big seas compounded over days can be astronomical. This is when mechanical self-steering proves so valuable – it requires no power and the windier it gets the better it steers. Even if the autopilot itself never fails OR if you have a second one, failures of many other systems can stop the flow of electricity and, in turn, render an autopilot useless. Windvanes are very reliable and steering a wind based course means your sails are always trimmed. With an auxiliary rudder type windvane, you are also gaining a completely separate emergency steering system/rudder which every offshore boat should have high on their priority list.

BONUS: So, can I install one of these things on my powerboat?
Lol. We get this one at every boat show… the answer is No.

Viki Moore Astrolabe Island Cruising New Zealand

Thanks to Viki Moore from Island Cruising for this article from Cruise News – The Newsletter of Island Cruising NZ

 

Island Cruising NZ Viki Moore

Essential Knots: Figure of eight

Essential Knots: Figure of eight Use: Stopper knot, prevents a rope from being pulled through a hole e.g. through a block or...

Anchoring – getting it right

If you can set an anchor correctly with confidence and know your boat will be safe in a secure anchorage, then you can rest in comfort and will not...

Jester Challenge 2022 – Sailing single handed from Plymouth UK to the Azores: Part 8 – Arriving at the Azores

Jester Challenge – A modern experiment in old-fashioned self-reliance, self sufficiency, and personal responsibility. This is the eighth of a 10-part post where solo sailor, Bernie Branfield, shares his first-hand account of his single-handed, 2022 Jester Challenge, from Plymouth, UK to the Azores, in his 26′ Invicta Mk2, Louisa.

Cutless bearing replacement

Cutless bearings can last for many years but if the propeller shaft is out of alignment they will wear through more quickly. If you have noticed a clunking sound when motoring then it could be a worn cutless bearing that is causing the problem.

Hourly Checks when sailing or motoring

  Hourly Checks Get into the habit of carrying out these checks and both yourself, your crew and your boat will be...

Avoiding personal dangers at sea

In order to stay safe at sea, we need to know the risks we are facing and to be aware of any personal dangers we could possibly encounter. Here are six of the most common potential dangers individual crew members should be aware of.

Docking a Motorboat

Docking a motorboat can be a challenging task, especially for beginners, but with practice and attention to detail, it becomes much easier. Here’s a step-by-step guide to help you dock your motorboat safely and efficiently.

Essential Yachting + Power Boat Safety Briefing

Yachting Safety Briefing   Down below Lifejackets and harnesses - fitting, when to wear, clipping on Gas - risks, precautions, gas bottles and...

Boat batteries

Under-sized battery banks are one of the key factors behind power failure at sea, as well as the premature failure of batteries, so make sure that your boat battery measures up to the use you want to put it to.

Jester Challenge 2022 – Sailing single handed from Plymouth UK to the Azores: Part 9 – Around the Azores

Jester Challenge – A modern experiment in old-fashioned self-reliance, self sufficiency, and personal responsibility. This is the ninth of a 10-part post where solo sailor, Bernie Branfield, shares his first-hand account of his single-handed, 2022 Jester Challenge, from Plymouth, UK to the Azores, in his 26′ Invicta Mk2, Louisa.

How to cope with an emergency at sea

A safe skipper will be mentally prepared for all kinds of potential emergencies happening at sea, including medical emergencies, engine failure, fire, a holed hull, capsize and dismasting.

Estimating and plotting your position at sea

This post covers how we go about estimating and plotting our position using traditional methods, when out of sight of land – covering Dead Reckoning, Estimated Position, Tidal Streams, Leeway and more…

Jester Challenge 2022 – Sailing single handed from Plymouth UK to the Azores: Part 3 – Preparations

Jester Challenge – A modern experiment in old-fashioned self-reliance, self sufficiency, and personal responsibility. This is the third of a 10-part post where solo sailor, Bernie Branfield, shares his first hand account of his single-handed, 2022 Jester Challenge, from Plymouth, UK to the Azores, in his 26′ Invicta Mk2, Louisa.

How to trim a genoa sail

I recently had two new sails made by Sanders Sails, based in Lymington UK. The first to arrive was the new genoa and it took me a little while to get to know it and learn how to adjust it correctly. Here is an aide memoire for getting to know how to trim a genoa so that it will deliver the best performance.

Safety Briefings – leave nothing to chance

Before giving your crew a safety briefing, it is worth considering the specific circumstances of the planned trip, the...

VHF DSC radio – how best to communicate at sea

There are many ways to communicate with others at sea. What makes the VHF DSC radio the best form of short range...

Boat maintenance below decks

While most interior maintenance work can be done when a boat is afloat, some jobs such as servicing the seacocks have to be done ashore. It makes sense to do any major interior repairs and improvements with the boat hauled out in the boatyard.

Dag Pike’s Boat Survey

We're really pleased to be working with Dag Pike on some great new apps for iPhone & Android. Here'a a bit more about the first app: Dag Pike's...

Tacking a sailing boat

Tacking is the sailing manoeuvre used to change a boat's direction through an oncoming wind. Tacking a sailing boat calls for the crew to work as a...

Gybing a sailing boat

Gybing is the sailing manoeuvre used to change a boat's direction through a following wind. As with the tacking manoeuvre, gybing a sailing boat...

Essential boat engine checklist

Boat engine checklist Engine oil level check Even if you have checked it previously, confirming the engine oil level is up...

2023 Rolex Fastnet Race – Part 2

Simon Jollands took part in the 2023 Rolex Fastnet Race. This is the second of his articles on the race aboard Lancelot II, a Beneteau First 40.

Going aground – what to do if it happens to you

When a yacht runs aground, it can be a stressful situation, especially on a falling tide in an exposed position with a swell running. There are several steps you can take to address the situation in order to ensure the safety of your vessel and its occupants. Here are some tips should this happen to you.

Propeller care and maintenance

Propellers are complicated and repairs should be done by specialists but owners can carry out checks and some routine maintenance themselves when the boat is in the boatyard. A propeller is critical to a boat’s performance, fuel consumption and ride, so it makes sense to keep a propeller in good working order.

The Boatyard Book – a boat owner’s guide to yacht maintenance, repair and refitting

The Boatyard Book is a fully illustrated 224 page practical reference manual that provides advice for boat owners on planning and carrying out annual maintenance, repairs, upgrades and refits of sailing yachts and motorboats, up to 20 metres in length.